How To Disassemble A Mossberg 500

Welcome to the TFB Field Strip series. We will disassemble the Mossberg 500 in this edition. The field-strip procedure for the Mossberg 500 is very similar to the 505, 510, 535, 590, 835 models, as well as the Maverick 88 and 91 models. The only real meaning is whether your model has a take-down screw in place. on the barrel assembly or the removable cap at the end of the magazine. Before we begin, four gun safety rules are listed below for reminders.

All guns are always loaded.

Never let a muzzle cover anything you’re not willing to destroy.

Keep your finger off the trigger until your line of sight is on the target.

Be sure of your goals and what is off-target.

TFB SECTOR STRATEGY: MOSSBERG 500 SHOTGUNS

The Mossberg User Manual can be found HERE.Step 1. Press the Action Release Button immediately after the guard activates and opens the action. Check the magazine and magazine to make sure they are unloaded. Step 2. After making sure the weapon is safe, you can leave the action open. Unscrew the Release Screw (or magazine cap for similar models) at the end of the magazine. Undoing the screw will loosen the barrel assembly from the receiver. Step 3. Remove the barrel assembly from the receiver. You may have to completely or partially close the action while doing this. Read more: how to reduce the volume of a track in audioStep 4. Deleting the Pin retains the trigger group (just above the trigger). You can use a puncher or a screwdriver. The back of the trigger guard can then be pulled down and out of the receiver.Step 5. After the trigger group is removed, the Cartridge Breakers (red arrow) and the Cartridge Stop bars can be removed. Notice the red arrow pointing to the nub on the Interrupter. It fits into the hole on the right side of the receiver. The Toner Cartridge compartment is located on the left side of the receiver. Step 6. Move the action backwards until the Bolt Slide aligns with the collector clearance cutout, marked in yellow. Once lined up, the Slide Bolt can be pulled out. Step 7. Read more: How to sleep with an ear infection Since the Bolt Slide is gone, the Action and Arm Sliders can be slid off the front of the magazine. Step 8. The bolt is removed from the front of the collector, where the barrel is already. The bolt can be removed further down, though it’s fairly easy to clean without disassembling it completely. Step 9. To remove the Cartridge Lift (marked in pink inside the receiver), pull it up from inside the receiver, then pinch the long arms together. The arms with the nubs are in exposed holes on the receiver (just above the trigger group holding hole seen in the photo above). Step 10.Removing the Magazine Tube is not always necessary but you can do it for occasional cleaning. Be careful when you open the Magazine because the spring inside is under a little pressure. The follower will be loose so keep your hand close to the receiver.Reassemble in reverse order and complete functional testing before storing your Mossberg 500.Read more: How to make a nail cross necklace

Last, Wallx.net sent you details about the topic “How To Disassemble A Mossberg 500❤️️”.Hope with useful information that the article “How To Disassemble A Mossberg 500” It will help readers to be more interested in “How To Disassemble A Mossberg 500 [ ❤️️❤️️ ]”.

Posts “How To Disassemble A Mossberg 500” posted by on 2021-09-03 18:35:52. Thank you for reading the article at wallx.net