How To Make Flu Flu Arrows

One of the most beautiful and useful parts of a wild turkey is its wing feathers. Usually, hunters remove the wings, but in fact, the feathers have many uses. I keep them mainly for artwork and decoration. But one of my favorites is the spiral-wrapped turkey-wing flu arrow. This causes the arrows to fly only a short distance and it can often be found sticking to the ground with a wag in the air above the grass. Anti-flu arrows are a great way to shoot at aerial targets and are ideal for hunting rabbits and birds. to make yourself. Unlike regular fletchings, you won’t need a template to cut them perfectly, or a feather burner or sander. Here’s a list of what you’ll need to make your own flu-fighting arrows:

Arrow shaft
Turkey feathers
super glue
Lanyard
Scissors / scissors / sharp utility knife
Tick
Clothespins or toast (optional)

Start with Clean Arrow Shaft

To get started, you’ll need a clean arrowhead and a few other essentials Beka Garris Read more: How to tell if your starter is bad First, you’ll want to make sure your arrowhead is clean . If they’ve been loaded before, make sure there’s nothing left. Use the utility knife to scrape off any remaining glue or debris if needed. You can also use rubbing alcohol to clean it, but it’s not necessary. You will notice that one side of the feather is much thicker than the other. Use the side of the brush with more feathers. With your shears, carefully separate the center brush from one end to the other. Remove the smaller side and cut the remaining brush on the larger side, the inside of the brush should look like white foam. Cut as much of this as possible. Your turkey feathers will need to be easy to bend to wrap around the arrow, so trimming the hard parts is essential.Continue reading: Traditional Archery: Basics of Traditional Archery

Attach your Feather Fletching

This is what the finished flu arrows will look like. Beka GarrisRead more: how to get coins and keys in a subway surfer Once your quill is trimmed, trim its thicker end so it’s flat and square. Add a drop of glue to the underside and apply to the shaft of your arrow, about a quarter to a half inch away from the arrow. The distance from the nape isn’t particularly important, I just want to use it as a measurement. Use a clothespin to hold the feather in place on the arrow until the glue dries. Next, run a line of glue from one end of the brush to the other. Grasp the feather in your hand, rotate the arrow clockwise (or counterclockwise depending on the natural curve of the bristles) so that the glue side of the brush wraps around the shaft. If you don’t want glue all over your hands, you can wear rubber gloves, which must be done quickly because you don’t want the glue to dry before you’ve finished wrapping. Once you have reached the end of the feather, clip it with a clothespin to let it dry. Add a drop of glue to the end of the bristles for extra support. After the glue dries, your arrow is complete, how tightly you wrap the feather is up to you. I want to measure the splint height of my bow to make sure I have enough room for the arrow to fit on the bow without the feathers obstructing the rest of the bow. The tighter you wrap it, the more the arrow will pull. You can also choose to use a second feather if needed, depending on your bow setup and weight. Read more: How to eat rice with chopsticks