How to Make and Use a DIY Water Level

This device really goes back to the basics, but to be honest sometimes the simplest devices are the best and cheapest. In its basic form, all you need is a length of clear tube and water. The principle and physics of water level is that water will find its own water level wherever it is placed. Sprinkle water on an uneven floor and it will always find low spots for you. Standby water level models will be the length of the tube with glass or plastic calibrated tanks at each end of the hose. Unlike laser levels and more important gauges, water levels can go around corners. together and the liquid in the tube should be at the same level next to each other. If not, there may be a blockage in the pipe or you may even be standing on a piece of pipe. You should agree with the other person you’re marking, whether you’re marking the low point of the concave or the high point.Mark the highs and lows First you need to make sure the length of the pipe you are using is long enough to reach all the locations you want to mark. Once the liquid has reached the level, you are ready to start marking. This is really a two person job as you will need several people at each end of the pipeline to confirm with each other when the level has been reached. the point you know is correct, then place your tube on the floor with your finger on top of the tube to prevent overflow.Basic water level components Bring the other end of the pipe to the points where you need to mark the correct height, hold it in the “close enough” position and release your finger from the end of the pipe, then the liquid will move up. and down in the tube until it settles.Mark the level using the water level Once it has settled, you have reached the level point between both ends of the pipe, then you can move the pipe up until the liquid reaches the required height. The other end of the pipe will be at the same height. Then you can mark your wall. This process can be repeated across an entire room or building area, giving you multiple points on the same level. You can connect these points with a sharp line using a chalk line. As always at DIY Doctor, we recommend using protective gloves, masks and eye protection when working with dust and debris.