How To Connect Recessed Lights In Series

If you will be installing recessed lighting, the wiring will have to be done in series for multiple lighting fixtures. The installation of many recessed lights in series is not difficult at all and can be completed in a relatively short period of time. Wiring a series of lights is similar to wiring just one. This is due to the fact that the connection series is essentially a long electrical conductor with several break points connected together by wire caps. This easy-to-follow step-by-step guide will show you everything you need to know to properly wire down lighting in your home.Step 1 – Turn off the power in the roomBefore you begin, make sure that you have turned off the power to the room in which you will install the recessed lighting. You can use a light switch connected to the recessed light to make sure the power is off, or you can open the switch box and test the connection with a multimeter.Step 2 – Install recessed lightingDetermine the layout plan for recessed lighting and install recessed lights into the ceiling. However, make sure you don’t tighten any caps or install bulbs until you’ve finished wiring.Step 3 – Cut length of wireRead more: how to make a straw from a beer bottle Get your tape measure and measure the distance between the recessed spotlights. Also, measure the distance between the junction box and the nearest recessed light. Then, get a pair of wire cutters and cut the Romex wire to a length about 4 to 6 inches longer than your measurements. This will give you enough extra wire to work with when making connections.Step 4 – Positive conductorStart wiring the black wire on the recessed light to the black wire on the Robinson power lead. Attach the connections to the wire caps and thread the pieces of wire between each recessed light. When you’re done making the connections, there should be three wires for each wire cap: one black wire for the fixture and two black for the sections of Romex power cords that are connecting the recessed lights.Step 5 – Negative conductorRead more: How to make a paper ball Using the same method you used to connect the positive or black wire, do the same for the white negative lead. Make sure that all exposed or bare wires are completely covered with wire caps.Step 6 – Connect the ground wireRun the bare copper wire or green wire used to ground each fixture to an appropriate ground. Or, you can bundle the ground wires together and connect them to a common ground the same way you would bundle black and white wires for fixtures.Step 7 – Join the connection in the junction boxRun the last piece of wire from the first fixture to the junction box that will be used to power your recessed lights. Then, connect the black, white and ground wires to the corresponding wires in the junction box and shield them with wire caps.Step 8 – Power onTurn the power back on, install the bulbs and enjoy your recessed lighting. Read more: how to change the co2 cartridge in a life jacket

Last, Wallx.net sent you details about the topic “How To Connect Recessed Lights In Series❤️️”.Hope with useful information that the article “How To Connect Recessed Lights In Series” It will help readers to be more interested in “How To Connect Recessed Lights In Series [ ❤️️❤️️ ]”.

Posts “How To Connect Recessed Lights In Series” posted by on 2021-10-24 12:39:06. Thank you for reading the article at wallx.net