How to Use Hammock Tree Straps: 5 Steps (w/ Videos!)

How to Use a Hammock Strap: 5 Steps (w/ Videos!) Learning how to use a hammock harness only takes a few minutes. You just need some tree-friendly hammock straps, a hammock, and a few plants to hang the hammock on. get it!

Step 1: Wrap one of your hammock straps around the tree

Contents

Remove one of your straps and wrap it around a tree.Tip: You should hang the hammock high enough that the bottom of the hammock is about 18 inches off the ground. To achieve this, you usually want to wrap your straps at about 5 or 6 feet.

Step 2: Load the end with attachment points through the loop at the opposite end

Specify the end position with attachment points. Get the endpoint by the attachment points through the loop at the opposite end.

Step 3: Pull the end with the attachment points to tie the rope around the tree

You want to pull your strap tight so it doesn’t slide down the tree. Read more: How to Bottle Mead Make any adjustments, if needed. For example, you may want to raise or lower the strap. I want my adjustment so that the position where the strap exits the loop is towards the other tree. You just hung up your first hammock strap! Now you repeat the process for the other one.

Step 4: Repeat steps 1-3 for other hammock straps

Wrap the remaining wire around the other tree. Feed the end with attachment points through the loop on the other end. Tighten the strap and make any adjustments, if necessary. Here’s an accelerated video of the complete process: Now both straps are set up! It’s time to hang the hammock.

Step 5: Clip your Hammock to the straps

Clip the hammock racks to one of the strap’s attachment points. Pull the other end of the hammock over the other tree and clip onto the other strap. Get into your hammock and see how it feels! Make any adjustments to improve the angle or height of the mount. You can change the attachment point your hammock is clamped to, raise or lower the straps, or even tie one of the straps around another tree. : Destiny 2 weird cookie making And so on …… you’re done! Now you know how to use hammock straps. Get into your hammock and RELAX. You have earned this.I have focused on using hammock straps to hook the hammock up in a tree. But you can also use these same steps to hang a hammock from a porch, balcony, wooden post, etc.Note: I used the popular ENO Atlas straps and the ENO DoubleNest hammock in this tutorial. But these instructions will work with almost any hammock and hammock harness.

How to use hammock straps in a tree-friendly way: 7 do’s and don’ts

Swinging can damage trees. To limit your impact, here are some approved no-track tips that you need to keep in mind when using hammock straps.

DO use tree-friendly hammock straps. These straps are at least 0.75 inches wide and are made of fabric that goes around the tree to minimize damage.

DO make sure your area allows hammocks in trees. Some public lands, such as some city and state parks, have banned tree hammocks.

DO inspect trees and the ground for sensitive plant life, wildlife habitat, and potential hazards such as poison ivy or beehives. Ideally, the trees and surrounding area should have little or no ground cover.

DO NOT hammer or screw anything into the tree. Your straps will be self-sustaining.

DO NOT use straps made from unfriendly materials. Materials such as rope or plastic rope can damage the bark.

DO NOT wrap the straps around dead trees or trees with dead branches. You can be injured if a branch falls.

DO NOT wrap straps around bent plants or trees in wet areas. You can pluck them by bouncing off them.