how to reset a clock spring

In this article, we will learn together how to properly install a new watch spring. If you don’t align the new watch spring, it will fail soon after it is installed, we see too many cases where the owner or repairman replaces the watch spring and within a few days or in some cases , immediately the new clock spring is broken. . This, of course, resulted in the airbag light coming on and several other warning lights. (center). If the watch spring is not centered, it will stretch the inner band and break immediately after installation.

How to set the clock spring properly

Contents

Read more: how to get a management consulting job

Make sure the wheel is facing straight ahead.

Remove the old clock spring from the car.

Without installing a new watch spring, turn the inside of the watch to the left until you feel resistance. Do not push when you feel resistance.

Turn the inside of the watch spring to the right and count the full revolutions.

In most cases you will get five full turns. Divide the number you get by two. In this case 5/2 = 2.5

Turn the inside of the watch spring 2.5 times back. This will put the clock spring in the middle.

Install the steering wheel.

Setting the clock spring (centering the clock spring) is very simple and should be completed with care. Note that some cars integrate the steering angle sensor into the meter spring. If your vehicle has a built-in steering angle sensor, you will need to reset the odometer spring/steering sensor.

How to reset a clock spring?

There are two ways to reset the steering angle sensor that is inside the watch spring. The first method is very simple and does not require any tools.

Start the engine and let it idle.

Turn the steering wheel all the way to the right.

Turn the steering wheel all the way to the left.

Repeat this process twice while the engine is running.

Drive at least 50 feet and the steering angle sensor will reset.

In most cases, this will reset the gauge spring and steering angle sensor, and it will turn off the ABS and stability control lights. If the above procedure does not work, you will need an OBD-II scanner to perform a steering angle reset. Connect the scanner to the diagnostic port under the dashboard and follow the on-screen instructions to reset the steering angle sensor.

Does the new watch spring need to be programmed?

Read more: how to unsubscribe from a podcast on SpotifyNo, the watch spring will work on its own without programming. Start the car and turn the wheel all the way to the left and then to the right a few times. This will reset the steering angle sensor in most cars. If this procedure does not work on your vehicle, use the Multi-System OBD2 Scanner with SAS Reset Function.

My new watch spring broke right after I installed it.

If your newly installed clock spring fails immediately after you install it, you or your mechanic did not install it correctly. The watch springs are not centered and the inner band is overstretched and breaks when you turn the steering wheel left or right. See instructions above on how to center the watch spring. Read more: stellaris how to win a war | Top Q&A