How To Mount Power Strip To Wall

Many of us have had the experience of kneeling on the floor, trying to plug a computer cord into a power strip on the floor. This is a pain in the neck, especially for older people or when you’re trying to troubleshoot a problem that requires repeated plugging and unplugging. Here we present ways to mount the power strip on a wall or furniture at a comfortable height for easier access to power. Some power strips have mounting holes, others do not. For the first type, you will need tools such as an electric screwdriver, 2 wafer head screws, 2 plastic anchors and a pencil; for the second type, you will only need a hook & loop lanyard with double-sided tape and a pair of scissors. so make sure its cord length is long enough to reach the nearest wall outlet. The installation height depends on where you are using the power strip. For example, when you are using the power strip for computers and peripherals, the best installation height is shoulder height when you sit down; When you are using the power strip in the kitchen, its best installation height is a little above the stovetop.Attach power stripRead more: how to tie a dry fly adamsWith screwMeasure the distance of the mounting holes on the back of the power strip, then use a pencil and ruler to mark 2 drill points on the wall/furniture with equal distances. Drive the 2 pilot holes with a screwdriver with the same screw diameter, same depth of the plastic dowels, then tap the 2 plastic dowels into the pilot holes until they are flush with the wall/furniture. Finally, pass 2 screws into the plastic anchors, leaving about 3-5mm protruding from the wall/table. The final step is to attach the power strip to the screws and slide it into place.With Hook & Loop PinIt’s easier to mount the power strip this way as you don’t need to drill holes in the wall or furniture and you can mount the power strip in any direction on the wall and under the counter. The first step is to clean the wall/furniture surface and the back of the electrical strip with a dry cloth so that the double-sided tape can adhere to them firmly. Then cut the hook & loop fastener into 2 stripes, and attach the “hook” side to the wall and the “ring” side to the electrical strip and make sure they meet when you press the power strip against the wall or furniture. Read more: How to high five on pelotonMountable power strip SUPERDANNY3. plug in the cordYou can now plug the cord into a wall outlet and turn on the power switch if available. wall, please comment here below. Read more: how to reset pioneer radio