How To Make A Lucky Rabbit Foot
Video How to make lucky rabbit feetThis is the process we used to make our bunny paw keychain. Read: how to make a lucky rabbit paw You can also watch the video version of this Tutorial here: How to make a bunny paw keychainNecessary items: (link link below) Rabbit feet 70% isopropyl alcohol (cleaning alcohol) Get it here Borax Get it hereWaterJar/container Get it hereRead more: How to set up hero cloning with rb4Bells drum or end caps Get it’s here Get it hereFind rabbit feet: We have meat rabbits that we also use to make keychains for rabbit legs and fur. Cut the foot to the desired length. I keep mine as long as possible, cutting them as close to the joint as possible. We used a pruner to trim the legs. Read more: How to clean your touchpad
Cut rabbit legs to desired lengthBrush foot: Wash your feet with warm water and dish soap. Repeat the process 2 or 3 times until they are clean. Rinse well after washing.First time soaking: Find a jar and some 70% Isopropyl alcohol (cleansing alcohol). Put all the feet in the jar and add the rubbing alcohol until the feet are sealed. Soak feet for 48 hours.
Soak your feet in wineWash: Wash your feet with water until the alcohol is gone. Squeeze as much water out of your feet as possible. Read more: How to tell your parents you’re an atheistSecond soak: If you have a second jar, you can save the wine for the next time you make pork leg. If not, rinse the wine in the jar, put the pork leg in the jar, add water and borax. The amount of solder will depend on how many feet you are processing. Dissolve as much borax in the water as possible (the borax may not dissolve completely and that’s okay). Keep your feet in this solution for 24 hours.Wash: Rinse feet with water to ensure all solder is removed. Squeeze out excess water.Dry your feet: I hang my feet to dry, but I also see people using an induction hob cooler. Dry your feet for 24-48 hours.
Hanging feet to dryPrepare the bell: Take the pliers and open the jingle bell to remove the small ball inside. Pry open all sides of the bell so the rabbit’s feet can slide into the bell. End caps can also be purchased with different designs if you wish.
The bell is opened and the small ball is taken outAttach ball chain: There is a small hole on the top of the bell to attach a ball chain or key chain. I attached my ball chain before adding the epoxy to make sure the opening wasn’t closed by the epoxy.Epoxy: I made sure all my pins would fit on the bell before adding the epoxy. Add a small amount of epoxy to the bell where the foot will go. Push your foot into the bell as far as you can. Let the epoxy dry for the recommended packaging time.
Make sure the foot will fit the bell before adding epoxyClosing latch: Finish your foot by closing the bell with your pliers so that the sides of the bell press firmly against the foot.
Completed KeychainTo watch a video of the process, click the link Happy Hills Homestead Rabbitpaw KeychainRead more: How to clean your trackpad
Last, Wallx.net sent you details about the topic “How To Make A Lucky Rabbit Foot❤️️”.Hope with useful information that the article “How To Make A Lucky Rabbit Foot” It will help readers to be more interested in “How To Make A Lucky Rabbit Foot [ ❤️️❤️️ ]”.
Posts “How To Make A Lucky Rabbit Foot” posted by on 2021-11-16 06:29:29. Thank you for reading the article at wallx.net
