How To Make A Cuff Bracelet With Beads

Total time: about an hour Bracelet: 1 cuff Read: how to make a bracelet with a cuff home

  • Pony Beads 9mm *
  • 30 beads each red and purple
  • 15 each orange, yellow, cyan, and indigo beads*
  • 4 .7mm . stretch magic jewelry wire

* Any 7 different colors can be used. To make a cuff larger or smaller, change the count by a number in uniform increments. 28 beads will fit the wrists of women or smaller children. Cut a few pins of wire to get started. You’ll tie it at the end of each row so you can easily add string as needed. You can do the whole bracelet with a long stretch but it can be more uncomfortable for beginners. I usually knot the ends together the next time I go around for extra reinforcement. If you thread the longer end through some of the seeds in the middle before trimming them, you can prevent the pull knot from pulling out when stretched.

  • Take the first set of 30 red beads and string them onto the string. Tie it in a square knot (right to left, then left to right) to form a necklace and then tie it back. Pull hard to ensure that the rope stays tied, as it is very slippery and easy to remove. This is a good time to check the width on your wrist and adjust. Thread the rope through the entire bracelet a second time and tie it securely.
  • Push the nearest red bead onto the tied string and thread it through. Take an orange bead and string it on a bracelet. The orange bead will push the neighboring red bead down, creating a zig zag. Go over to the next red bead and string another orange bead into the bracelet.
  • Continue adding the orange beads. They will alternate like bricks between other red beads. The hoop will start out like a flower but will unfold as you add rows later. Continue until you have added all 15 beads, then fasten it off.
  • Add the yellow beads in the same pattern, remembering to tie and adjust the tension at the end of that row. The cuff should start pulling into the correct shape now, making this process easier.
  • Continue adding rows of colored beads in the correct order to your pattern. At the end of each row, double-check to make sure you haven’t made any mistakes before tying the row out. Your last row will be a double row of purple beads.
  • Thread the string through the last two rows of purple beads and secure. Cut or re-tie any loose ends. Stretch it out to check for knots. Your bracelet is done.Rainbow Beads
    • See Also  4 Powerful Reasons To Change The Past, With A Short Guide

    While the supplies list the classic ROY G BIV rainbow colors, you can actually use any graduated palette to create a rainbow look. The mixed bead set is not red, so I used pink. I used cyan as the seventh color to allow me to alternate between pearls and sparkles. Indigo and purple can be quite complicated as most sets have one blue and one purple. In the clear rainbow bracelet below, I used a blue-green color, for a more dramatic rainbow add double rows of each color (30 beads each) with triple rows for the ends. (45 seeds). Or you can change between 14 graduated colors, just starting and ending with a double row. Read more: how to use torpedoes in the world of warshipsRainbow Beads

    Last, Wallx.net sent you details about the topic “How To Make A Cuff Bracelet With Beads❤️️”.Hope with useful information that the article “How To Make A Cuff Bracelet With Beads” It will help readers to be more interested in “How To Make A Cuff Bracelet With Beads [ ❤️️❤️️ ]”.

    Posts “How To Make A Cuff Bracelet With Beads” posted by on 2021-11-04 16:29:39. Thank you for reading the article at wallx.net

    Rate this post
    Back to top button