How To Install Swimming Pool Led Strip Lights

Lighting the inside of an above ground pool can make nighttime swimming more enjoyable. But finding a way to evenly illuminate an entire space from one source can be difficult. Use our instructions below to create a solution for connecting and powering long running LED strips. It can be used for any project that requires multiple light strips to be linked together and rely on a single power source. . With several color changing patterns and watertight textures, these light strips create a fun atmosphere for both kids and adults. Customize brightness, color, and dynamics with an optional remote to adjust lighting to suit any event.

Shop all LED strip lights now!

Note: Some cities require aboveground pool lighting to meet National Electrical Code (NEC) Article 680 standards, which will restrict lighting installation locations. possible swimming pool. Before you buy LED pool lights, check your city’s code requirements. We also recommend having a certified electrician install your lights.Material:(1) DiodeDrive® Series 240W Power Supply (1) CPS Box to Terminals (1) LC4 RGB Controller and Remote Control (1) LC4 Splitter Cable (2) LC4 Pigtail Power Connector (piece) (8) Waterproof nut (4) Waterproof RGB LED StripRecommended Tools and Materials: (Depending on weather needs and installation location) 12mm double-sided 3M foam gasket 12mm silicone terminations Dolphin connector with silicone sealant seal 18-gauge two-conductor Wiring 12 mm Electrical Tape Mounting Electrical Tape 3M Speed Accelerator Nuts / Cotter Pins1) MeasurementBefore ordering your LED strip lights, measure the diameter of your pool and multiply by 3.14 to find its circumference; This number indicates total length of strip that you will need. The 21-foot pool used for these installation instructions has a circumference of 65.94 feet and requires 4 16-foot LED strips.2) Power setting Read more: how to download drm protected video Before you’re ready to install your LED strip lights, make sure to drain your swimming pool. Start by creating or locating a dry area away from your pool for power supply. The power supply must be contained in a weatherproof box. Power must be installed between the earth fault circuit interrupter (GFCI) circuit and the pool junction box. It is important to use a GFCI protected circuit, as it will turn off if current flows where it is not allowed. Connect the plug that came with the power supply, but do not connect it until the installation is complete.3) Controller Setup Using the CPS barrel connector, connect power to the LC4 controller.4) Connecting RGB LED stripsConnect the controller output LC4 connector to the LC4 splitter. Then connect the LC4 braid to the braids of the bands. Use a waterproof nut to seal your connection. Connect strips 1 and 3 together using the connectors already attached to the strips. Repeat for strips 2 and 4.5) Mounting the RGB LED strips You will stick strips 1 and 3 clockwise around your pool rim and strips 2 and 4 counterclockwise. under your pool rim, drill small holes in the truss about every 2 feet. Use the lanyard to anchor the strip to the truss. You can also use a speed nut or cotter pin to anchor the strip to avoid boreholes.6) Power onRead more: how to get rid of fishy odors in your car Plug the included power cord into the outlet and enjoy your LED pool lighting! Fill your pool with water but make sure to leave space between the water line and the lights. Our large collection features single color, color shift, and color cast options. Complete your outdoor space with our wide selection of landscape lights—from motion sensor security lighting to decorative patio and patio lighting.For technical questions, don’t hesitate to call us toll free at 866-590-3533. Our customer service and technical support team is available from 8:30 a.m. to 8 p.m. CDT Monday through Thursday and 8:30 a.m. to 4 p.m. CDT on Friday.Read more: How to make your wife crazy in bed