How To Get Rid Of Large Bodies Of Water In Minecraft

There are two good ways to do this, I call them the Gravity Method and the Fire Method. Both were tested in this 8 x 8 area in a shallow river to compare the two:Read: how to get rid of big water blocks in minecraft

Gravity method

Contents

Use a gravity block (sand or gravel) and fill the area. Do this by quickly placing the blocks in the same place, while letting them fall to the bottom:put a block of gravel in a cornerRepeat this until you have filled the entire area with sand or gravel:the whole cube is now filled with gravelDig to the bottom in one of the corners until you’re under a solid block under the gravel:dig to a block below the gravelRemove a block below the solid block holding the gravel and place a torch:put a torch on the ground clinging to the gravelDestroy the block above the torch and absorb all dropped blocks:destroy the soil clinging to the gravelRepeat this process until you have cleared the entire area:the cube is empty, there is a torch at the bottom

Fire fighting method

Read more: How to tell if a guppies are male or female This method only works if the area’s outer fence is not flammable, otherwise it will create a mess. First, use flammable blocks to fill that area. I used wool for the demonstration, but a more cost-effective option would be to use wooden planks or harvest leaves from the tree with scissors.the whole cube is filled with lenGet flint and steel and BURN!the flame consumes the wool, leaving empty space in its placeTa-da!again, the cube is empty

Note:

After looking at the end result, you can see that the Gravity Method required me to dig deeper into the Fire Method, thus taking longer. The Fire Method is generally faster; takes longer to fill the area with blocks, but burns all the wool in about 30 seconds. The Fire Method is my personal favorite.

See Also  How to store loose leaf tea

World Edit

If you have access to worldedit you can select the region by using your wand (// wand) or by using // pos1 and // pos2 and then using the // Replace command water air. This will replace all water in the area with air. I tested this command on a pretty landscape to demonstrate:a river flowing in a hilly landscapeRead more: How to enter the sinkhole in the forest After the command // Replace water air:the river was cut suddenly

1.8 Update

Note: screenshot was taken in Snapshot 14w28b.The upcoming 1.8 update brings the sponge back to survival mode, creating another option to remove water. Wet sponges can be obtained at Ocean Monument or by defeating the Elder Guardian, which are then dried in the oven for a dried sponge. To test the sponge’s usability, I created another enclosed area, much deeper this time, to test the sponge’s performance against the other methods stated earlier:a cube with a wall around a riverThe first thing you’ll notice about the new sponges is that once they’re placed, the area they’re soaked in fills up again immediately if there are enough water source blocks around: Just like a sponge is cleaned. put:the water flows back to cover the spots emptied by the spongeAfter the water has been refilled:The sponge can no longer absorb water and the area around it is filled with water againI’ve found that the only way to get the sponge to work somewhat effectively is to divide the area into sections, using one sponge in each section. The problem with this is that you have to do this for each level, which will be very time consuming:divide each level into areas that a single sponge can handleObviously sponges are not very good at removing large amounts of water. However, they are useful for emptying small ponds or draining water in a small room. I still recommend using the Gravity Method or the Fire Method for wider or deeper areas, as they are quicker and easier than using a sponge. Read more: how to style a bell sleeve shirt.

See Also  How to clean a tea kettle

Last, Wallx.net sent you details about the topic “How To Get Rid Of Large Bodies Of Water In Minecraft❤️️”.Hope with useful information that the article “How To Get Rid Of Large Bodies Of Water In Minecraft” It will help readers to be more interested in “How To Get Rid Of Large Bodies Of Water In Minecraft [ ❤️️❤️️ ]”.

Posts “How To Get Rid Of Large Bodies Of Water In Minecraft” posted by on 2021-10-20 09:35:15. Thank you for reading the article at wallx.net

Rate this post
Back to top button