How To Clean Smoke Damage From Wood

How do you clean up smoke damage from wood? What you should do is gently wipe the wood with a soft cloth and then vacuum the wood to remove the soot. When it comes to removing soot, each type of wood requires a specific process. However, it is possible that the damage goes beyond the surface. The more you let the smoke linger, the more it soaks into the wood; therefore, wood cleaning should be done sooner rather than later. Before starting the cleaning process, you should determine if the wood is finished or unfinished. This article will present a quick guide on how to clean up smoke damage from wood.

How to clean up smoke damage from wood

Clean soot from finished woodRead: how to clean smoke damage from wood Finished wood is covered with a protective coating to make it look shiny. It should be cleaned with a duster or high efficiency granular air cleaner (HEPA). Both will pick up dry soot before you start cleaning deeper into the wood. There are special suction machines made to do the trick. Then, clean the area with a dry chemical sponge until the surface turns black. Read more: Bread omelette recipe | Top Q & AF For best results, make sure the sponge is dry. Pay attention to the pressure you apply to the sponge as it can permanently adhere to the smoke residue. If the wood is affected by smoke, stroke the wood surface with your hand. To clean the soot, scrub the surface with a cotton rag or oil soap. But if more agitation is needed, you can use steel wool and work in the direction of the grain. This will help protect the surface of the wood. If soot remains on the wood, dilute the degreaser in a bowl and spread it over the wood. Then, rinse with a wet cloth and pat dry with a soft cloth. You may also want to rub a bit of polish on the woodwork, which will help you remove unattractive marks.Cleaning soot from unfinished woodUnfinished wood comes with a varying degree of roughness. The soot will soak into the wood a few minutes after burning. You should use a specialized deodorant spray to eliminate the smell of smoke spreading on wooden surfaces. Second, remove soot with a vacuum Read more: how to put your Mac in airplane mode For a deep clean, run a HEPA vacuum on a dusty surface. This will help you pick up as much soot as possible. Third, use a chemical sponge to sweep all over the wood surface. When one side of the sponge turns black, flip it over to the other side. To reveal the new wood, cut the blackened parts. In addition, dilute a little degreaser with water and spray evenly on the wood surface. Since unfinished wood is more susceptible to smoke than finished wood, you should scrub away any remaining stains. You can also use fine sandpaper to tackle heavy stains. In no time, your unfinished work will be as good as new. Make sure you seal the unfinished part.EpilogueHow do you clean up smoke damage from wood? Use a soft cloth and HEPA vacuum to clean finished wood or a deodorizer spray to clean unfinished wood. While you can’t salvage everything in your home after a fire, you can clean your smoke-damaged furniture. By following the instructions above, you will return the furniture to like-new condition. It is important that you clean the surface immediately to reverse the effects of damage. Read more: how to remove seeds from raspberry jam