How To Change A Headlight On A 2009 Chevy Malibu

Video How to change the headlight bulb on the Chevy Malibu 2009 Changing the headlight bulb on the Chevy Malibu can be a bit complicated. You will have to remove at least part of the front bumper to get to the headlight assembly and access the headlight bulb. While this isn’t the most difficult car to change a headlight bulb, it can be one of the more time consuming. Follow these instructions to make the process a little easier.Read: how to change headlights on 2009 chevy malibu NOTE: This is a great video on the headlight removal procedure that will make bulb replacement much easier. Step 1: First, remove the eleven 10mm bolts and four plastic studs that hold the radiator cap down. Step 2: After you remove the plastic bolts and studs, lift off the radiator cap and set it aside. Step 3:Read more: How to budget in latex Turn the steering wheel in the opposite direction of the burned-out bulb to make enough room in the wheel well area. Some people may find it easier to just completely remove the front wheel of the vehicle for more work space. Step 4: Going below the front bumper, you will need to locate the 7mm bolts on the plastic cover underneath and remove them. There is also a plastic rivet on each side that needs to be removed. Step 5: Next, remove the studs that secure the wheel liner and pull the liner back to access the two 10mm bolts holding the bumper in place. The latch closest to you will need to be removed, while the one closest to the outside of the vehicle will only need to be loosened. Step 6: Now that you’re at the headlight assembly, you’ll notice that it’s held in place by four 10mm bolts. Remove these bolts and pull the bracket above the headlight. Step 7:Read more: How to get skins in Minecraft The final headlight assembly won’t be on the car and the bulbs are now usable. To distinguish the headlight bulb apart from the high beam – the high beam has a light blue plastic label. To remove the bulb, take the base and turn it 1/4 turn counterclockwise to unlock and pull straight out. Step 8: Pull the bulb from the power connector, you may have to use a flathead screwdriver to remove it. Step 9: Insert the new bulb and push the base into the headlight assembly. Step 10: From here, it’s a matter of reversing these steps and putting everything back where it was. *Note, while you may notice that a particular light bulb burns out, checking the rest while you’re in it may not be harmful for signs of damage. It might even be worth changing out all the bulbs while you’re at it so you don’t have to do the process again in a week because you’ve replaced a low beam, not a high beam. Read more: how to rotate a photo a bit. in paint