How To Attach A Deck To A Brick House

The ledger board, or header, is a horizontal piece of wood that is attached to the wall to support the ends of the deck braces. Ledgers can be attached using one of three methods.

“Through bolts” are led into brick or stone, then protrude through the ledger, where they are fastened with nuts.

The lagging pin is driven through the ledger and brick or partition and into the frame of the house.

Tapcon type concrete screws can be used as an alternative to bolts in many cases.

Read: how to attach a deck to a brick house

Close the wall ledger

Onto Tile Veneer

Read more: How to connect gopro to tv Read more: how to stop work because of timeout (Confirmed with local build code)To attach a ledger to the wall via brick veneer:

Mark anchor positions on your ledger and drill through the board with a ” bit

Position the ledger against the wall and mark the anchor locations through the hole in the wall.

Use a hammer drill to drill through the brick veneer with a ½ inch drill bit until you reach the back wood frame. Do not drill into wood.

Reposition the ledger board and insert a ½” delay pin, 10″ long, into each hole and push them in slightly with a hammer.

Use a socket wrench or impact driver to drive the bolts into the frame until the ledger is firmly attached to the wall.

Onto Siding

Read more: How to connect gopro to tv Read more: how to stop work because of timeout (Confirmed with local build code)When fastening to the wall, follow the same steps as above. Secure a spacer strip to hold the ledger board level. Read more: Rock Bass 101: How to catch the prized fish

Last, Wallx.net sent you details about the topic “How To Attach A Deck To A Brick House❤️️”.Hope with useful information that the article “How To Attach A Deck To A Brick House” It will help readers to be more interested in “How To Attach A Deck To A Brick House [ ❤️️❤️️ ]”.

Posts “How To Attach A Deck To A Brick House” posted by on 2021-11-07 15:55:23. Thank you for reading the article at wallx.net