how to align starter with flywheel

You can have the fastest or most stable car on campus at an event, but if you can’t start when it’s race time, all that performance potential won’t do you any good. Missing turns on the count at the hands of a damaged starter can be avoided by ensuring that it is set as soon as you start mounting your engine for the first time. start without any problems every time you press the ignition switch. Making sure your starter is correctly fitted to the engine is something you can easily forget, and it will prevent premature failure and wear on the equipment. If you have the gear on the starter wound properly, you should be able to grab it with pliers and remove it without any problems. If the fastener is too tight, it puts extra load on the teeth, and if the fastener is loose, it can cause the gear to hang in the transmission once the engine has started. Meziere Enterprises manufactures heavy duty starters designed for racing applications. Meziere could add some details on why making sure it’s important to have the right clearance for your starter, like the rear wheel of a race car. Installing your starter gear in relation to a flywheel or a bend gear will help ensure a long life for the gear set. If the distance between the two centers is too close, the surfaces of the gears will have pressure on each other, creating a lot of friction and noise. Over time, this will cause severe gear wear. If the centerline distance is too large, the point of contact between the two gears will be much higher than the face of the gear. The net effect is that it puts the gear teeth at a mechanical disadvantage and will be more likely to fracture. If the spacing is correct, the spur gear tooth face will rotate into the gap and contact the ring gear at the midpoint and exit without touching the back face. “Besides the clearance of the starter gear, you need to take into account how far the gear has to travel before it enters the gear. Not taking the time to make sure these measurements are correct can also lead to starting problems for your engine. Read more: how to clean old shoes “When resting, we recommend placing the gear 10 inches away from the gear. There’s some room here, but we don’t want to see anything smaller than 0.6 inches and no more than 0.14 inches. This measurement plays an important role in the gear lift magnetic insulation, ensuring that the gear rotates correctly into the ring gear and main power is applied at the right point in the cycle. If the gear is too close to the ring, it may collide and not allow the gear to enter. If the gap is too large, the gear may have too much rotation, or at best there may not be enough stroke to engage the ring gear completely,” says Meziere.By making sure you have the starter installed correctly, you’ll increase your engine’s spin and avoid problems like broken teeth on the starter or the dreaded no-start situation at the ready line. To learn more about getting the starter kit to align correctly, visit the Meziere Enterprises website right here. Read more: how to make the hamster wheel silent