Chest Masculinization

CHEST MASCULINIZATIONTransTape is made from a blend of 95% cotton and 5% spandex with a medical acrylic adhesive. It is latex-free and drug-free so it is hypoallergenic. However, with this said, you may experience irritation, itching, or redness or blistering after wearing TransTape. We recommend placing a small patch on the inside of your forearm with zero tension, then waiting FULL 24 HOURS to see if your skin reacts. Otherwise, you can continue to use TransTape. Read: how to apply transition tapeRead more: how to remove water stained with ritSTEP 1: For best adhesive properties, start with clean, fresh skin, without cream or oil. Wash with non-moisturizing soap; wash. (You may have to shave if it’s too much, a quarter inch cut is fine.)STEP 2: Make nipple covers. NEVER application TransTape directly on the nipple skin. ALWAYS wear a bandage or cover the nipple using a short band TransTape and a square of toilet paper. Cut 2 short strips, round the corners with scissors. Tear off the protective paper in 2 places and remove the middle piece. Fold a square of toilet paper in the 3rd second, then in the 3rd second again; create a pad. Glue the spacer to the center of your strip. Repeat for 2, apply with zero stretch.STEP 3: Choose the size or sizes that best suit YOUR body. Cut all the strips to size, then round the corners with scissors to avoid curling at the edges and for more contour. TransTape will last a lot, so start shorter than you think. We recommend starting with 3-4 sections (dark blue line) and adjust from there. For a smaller build, use 3 parts, an average build of 3.5-4 parts, and for a large and plus, start with 4 and adjust from there. You don’t want it extending to your back, protruding under your armpits. You only need 2 pieces on each side, up to 3 pieces. Less is better.STEP 4: With your thumb and forefinger, take your first strip at the first bold line, tear off the protective paper, let it stick TransTape. If you’re using multiple sizes and multiple pieces, get your widest band first. Remove the first part and discard. Peel off the second part, leaving the attached paper; fold and fold. This will create a handle so you don’t touch the sticky part, reducing the adhesive. Repeat this process with all your strips. Read more: How to pack candles for travelSTEP 5: Divide your chest into sections starting at the center of the collarbone, down through the sternum, and then again from the center of the sternum to each shoulder at an angle (you can use an eyeliner pencil or highlighter). washable mark to help create visual lines until you get the hang of it) Keep the area ice-free; This will allow you to wear a topless bra and will create the illusion of topless.STEP 6: Use your hands to push the breast tissue down and back. Line up your first piece with the part you created, outside the “open chest” area. Gently place the first 2 inches of TransTape on your skin and rub gently to activate the adhesive. Take your time, layer your breast tissues so that all the tissue can be tucked into the bandage. Be careful not to overprocess yours TransTape, as this will reduce the adhesive. Keep yours TransTape taught, avoid any wrinkles. Push your breast tissue flat, guiding the bandage into place. Once you’ve found a comfortable place for the tissue to rest under your armpit area, remove the last piece of protective paper and place the bandage smoothly without straining. Wow TransTape strong, create friction to activate the adhesive.STEP 7: At this point, you’re probably looking a bit silly and need a second piece to work it out. Take your second strip and prepare it the same way as the first. Glue the second strip back a few inches from the first, overlapping to create flatness. Again, push the tissue out of the way with your hands and fix the fat with TransTape. Make sure that the second strip passes over the first, making sure to make contact with the skin. TransTape Will not self-adhesive and will easily roll up if not properly attached to the skin. Repeat this process on the other side. Comfort is the goal. Make sure you can breathe and move freely, if you can’t, something has been done incorrectly. You can add an additional piece vertically under the armpit, covering the ends of the strip for extra security Read More: How to Build a Competitive Shiny Pokémon Army