How To Cut A Board In Half Thickness

Video How to cut a board to thickness What is the best way to divide these boards evenly (and roughly equally)? What tools do I need to buy? As you requested, I would focus on a hand-tool-only approach but fair warning, even on smaller boards this can be a lot of work and difficult to do correctly. On a 15-inch wide board, it will also pose a great physical challenge – working hard and for a number of hours.Traditional methodThe splitting of an existing plank you’re looking to do here is called re-saw, because you’re re-sawing what was previously sawed in a mill. older woodworking books, it will be quite simple in sketching: you start simply by marking or measuring your cut through between both the long sides and the top of the board, then, holding the work in the opposite direction , start sawing with a suitable saw (a butcheringspecially made for longitudinal sawing).Read more: how to build a wedding arch So the minimum set of tools for this would be:

ruler and pencil or marker
table saw, sharpened for cutting
a deputy to hold the embryo
one or more small wooden wedges to keep the kerf open
one or two plane arms to smooth the sawn surface
scraper and/or sandpaper to smooth the board

Note: the co-pilot must be attached to something quite sturdy and heavy, ideally immovable, so that energy is not wasted moving the table as you have seen. This is one of the reasons for the heavy weight of traditional woodworking benches. The above description of this method makes this sound pretty easy and straightforward but in reality it’s anything, especially on a board of considerable width and/or length.Modern methodThe above could be a significant improvement but unfortunately it requires more work or on your behalf because you need to build the #1 item in the tools list, kerfing plane. Read more about that here on the Unplugged Woodshop page, included with the video. The job of the kerfing plane here is to create a starting groove along all four sides of your board. Sawmillers naturally want to keep track of existing grooves (taking the path with the least amount of resistance), so this makes it much easier to see straight and true through the length of the board. This isn’t a 100% fix, but it helps a lot, so if you’re sawing a lot of things by hand, one of these is well worth the effort.

kerfing plane
universal table saw (see note below)
a deputy to hold the embryo
one or more small wooden wedges to keep the kerf open
one or two plane arms to smooth the sawn surface
scraper and/or sandpaper to smooth the board

Note: it can be difficult to find a good chainsaw these days and very expensive when you do find a chainsaw. As a result, many woodworkers actually purchase a general purpose board saw with a tooth shape that is different from the traditional western saw for cutting OR cross cutting. An example:This is a drawback as they do not tear or cut as well as specialized saws for these jobs, but they also have their advantages. Their teeth are pulse hardened or induction hardening which makes them much harder than traditional serrations, so teeth dull less quickly even for hard and tough woods, but especially when cutting man-made boards such as plywood and MDF. And the modern tooth shape means that they do some cutting on the pull stroke (as well as the main cut done on the push stroke). They are also considerably cheaper, perhaps 1/5 the price.Japanese sawToday, a lot of Western woodworkers use Asian saws (mostly Japanese, in fact) to cut some or all of them. These saws can be very efficient, track well and cut very cleanly and quickly because of the tooth shape but I don’t think you should consider one because of the maximum cutting length. Many of these saws have blades 250-300mm, one foot or smaller, and as soon as you cut an angle, the length of the cut will be significantly longer than your original length of 15″. . So to make your cuts you need to saw the entire length of the board twice (working from each long edge), which is almost twice the work in essence! Read more: how to get a hoarse voice