How To Remove A Wall Air Conditioner

Video How to Remove a Wall-mounted Air Conditioner by Dillon B. (additional article by Ryan O.) Most people assume that once an air conditioner unit is installed, it cannot be removed unless it is removed. Are you ready to deal with a large unsightly hole in the Wall. However, sometimes the AC unit gets old, there are other ways to cool the house, or you just don’t want it there. wall by installing drywall to reclaim your wall space. Read: how to remove the wall-mounted air conditionerPrepare to rebuild that wallHere’s what you’ll need for this DIY project: – Drywall with Phillips head drill bits, the same thickness as your existing wall ( inch most common), cut to size-1 ”x 1” common wood used to base drywall, measured to size-Splicing compound such as mud 20mins-Slipper blade-Drywall mesh tape-1 drywall screws 5 /8” -sandpaper (120 to 150 grit range recommended) -level/straight tape measureStep One: Remove the face shield and air unitRead more: Learn to crochet – how to hold the hook and thread After removing the face of the air conditioner unit, carefully slide the body of the unit off the holder. Air conditioning units are very heavy, so support is recommended.Step Two: Remove the air unit housing frameRemove the screws that secure the frame to the wall. The frame should be easily pulled out.Step three: Install drywall supportMeasure the four sides of the blank frame and cut four 1” x 1” pieces of wood to the measurements. It doesn’t have to be perfectly cut to size because it only serves as a base for the drywall to bolt on. Secure the wood paneling with drywall screws, attach to the wall screws when topqa.info. Make sure that when installing the base plate, the base plate needs to be concave to calculate the thickness of the drywall piece; the back side must support the piece so that it fits the same flat surface of the existing wall.Step Four: Cut the drywall pieceCut pieces of drywall, about the same thickness as your existing drywall. Drywall can be cut with a point cutter, using a utility knife or a saw to cut pieces to size. The piece should be about ¼” inch around the circumference of the hole to fit in the gap. Use a flat or straight cutter to make sure the piece fits snugly into the openings and corners. Topqa.info places the drywall piece in the gap, running your hand over the piece and wall to feel if they are flat. It will be like a continuous wall with a slight opening.Step Five: Installing the Drywall PieceRead more: how long does it take to cycle 20 miles | Top Q&A Screw the edges of the drywall piece into the spacer you installed earlier. We recommend that these screws be spaced 2-4 inches apart for a small piece like this and 6-8 inches apart for a full 8′ x 4′ inch piece of drywall. What’s more important is that the screws hold everything in place without using more screws than necessary; Many screws on these edges can affect the stability of the drywall plasterboard.Step six: Mud drywall joints and screwsCover the space between the wall and the drywall piece with drywall tape (mesh tape) all the way around. Use a putty knife to apply joint paste or plaster over the gap. Apply this compound to all drywall for consistency, but it should be emphasized that topqa.infot compound can harden in as little as 20 minutes, so work quickly. Apply about 2-3 coats, sanding after each coat until the wall is completely smooth to the touch.Step Seven: Sand the CompoundOnce dry, use dry compound sandpaper to even out the surface. This area is now ready for repainting. Check out more remodeling tips and videos here on our Best Online Cabinet blog! Read more: how to check if a crystal is real