How To Solder Deans Connectors To A Lipo Battery
One skill that you will quickly find as a great skill to have in the RC hobby is the ability to solder. Welding isn’t rocket science but it does require a bit of knowledge and of course there’s no substitute for gaining experience by actually getting a soldering iron and doing it.Tools and accessoriesRead: how to solder terminals to a lipo . battery
- soldering iron
- Hand assist device
- Deans . connector
- Flush
- Snips
- Welding wire
- Shrink tube
- Lighter or heat gun for shrink tubing
DetailsI highly recommend you to buy a good soldering iron and develop this skill as it will definitely help you to have a hobby of making joints yourself, repairing joints etc. Soldering iron is very important as even someone who is good at soldering is very important. will also let you know that if your iron is not a very good iron and is not reaching the proper temperature, you will have problems with your connections. A really great soldering iron that won’t break the bank but will most likely do whatever you need is the Hakko FX-888. I ordered my iron from Amazon and it cost about $100.Flux is an essential part of making good welds. You will read and hear many people say that you don’t need flux if you have good solder wire. This may be true in some cases, however, I’ve tried with good wire that doesn’t use flux and it still doesn’t work well for me. I think especially for those who are just starting to learn to solder you will have much greater success if you use more flux in your soldering technique. great work. What I like to do is dip the tip of my solder wire in flux and then let the wire/flow over my soldering iron.
Begin
- Set up your iron and let it start to heat up while you prep the batteries. First things first. Cut only one wire at a time as this is important to keep the battery terminals from touching each other and causing arcing. This can be a dangerous situation if you cut both wires at the same time. So again, only cut one wire at a time.
- As you can see here, I’ve cut the black wire (the negative) and have cut another quarter inch of the sheath back so we can go ahead and tin the wire and prepare to solder to the connector. You can see part of the process above. I want to press them down on the part you want to strip until you “feel” the peel cut down the wire. Simply move all the way around the cord to cut all the sheath and simply clamp down and pull the sheath aside.
Read more: 
- Tinned wire means we take some solder and let it run on the wire before we try to solder the wire to the connector. This makes the connection much easier and prepares the wire to accept the additional solder we will be adding to make the connection.
- We also “tin” the connector with a drop of solder to accomplish the same thing we did with the wire before making the connection
***Importance***
- Make sure you cut the shrink tube and slide it into the unconnected wire before making the connection. I can’t tell you how many times I’ve been frustrated with soldering my connector and then realized I hadn’t put any shrink tubing in.
- Using your helper, clamp your input connector on one side where it can be connected to a wire from your battery held by the other side of the helper. Apply your flux coated wire to your iron over the connection, letting the solder flow evenly over the connection until it is secure.
- Slide your heat shrink tube over the connection and apply heat to shrink.
Read more: how to make a reed oboe
Last, Wallx.net sent you details about the topic “How To Solder Deans Connectors To A Lipo Battery❤️️”.Hope with useful information that the article “How To Solder Deans Connectors To A Lipo Battery” It will help readers to be more interested in “How To Solder Deans Connectors To A Lipo Battery [ ❤️️❤️️ ]”.
Posts “How To Solder Deans Connectors To A Lipo Battery” posted by on 2021-11-04 06:20:20. Thank you for reading the article at wallx.net
